Good Morning Everyone,
I installed and managed mailman 2 for about two years. I am now ready to try Mailman 3. The documentation for version 2 was lucid and this forum was quite helpful in the past.
Now I'd like to proceed with installating MM3 but I doubt my understanding of the docs. It seems to assume that users will know what to do.
Okay, don't laugh! I just want to be sure what I am doing. Does the following sequence resemble the proper steps?
- Download the source from a git repo (I understood that one)
- Create a virtual environment (venv perhaps ... not stated explicitly)
- activate the virtual environment
- from the git project root, run: ./mailman start
I know, its stupid. I had to ask. It would really build my confidence someone would confirm the above steps or counter then with something very explicit. What about process ownership? Do I need to have a unix mailman user? What else do I need to get mailman up and running before proceeding to configuration. Ahaa! I perused the config docs a bit. Where can I find the .cfg file?
I hope these questions are not too annoying.
Regards Onyeibo