Folks,
I have been trying to set up a mailing list that is mostly for message distribution, so there is a single sender of messages and multiple receivers, but the receivers are moderated. I wouldn't mind receiver messages being explicitly rejected but that's not an issue for now.
I looked around the interface and decided to set up the sender as a non-member, as that appeared to permit them to be "special" and outside of the normal access rules for the list. Before I did that I could send a message from this sender and that would be sent to me as list owner for moderation, so both incoming (from my mailserver) and outgoing (to it) can be completed.
However, with a non-member who is auto-accepted the message is passed from my mailserver to mailman and then disappears. I cannot find anything in the logs to indicate what happened next. I have tried setting the default non-member policy to both 'hold' and 'default' with no change in that behaviour. The logs for the mailserver show the message being sent to mailman; mailman's "smtp.log" shows an LMTP message being received ok, and then nothing.
Any ideas how to find out what is going on? I can share config if that helps but not sure what would be useful.
As a side-issue, at one point I added a regex matching the sender address to the acceptable members list, but find that I cannot now delete it (using postorius): If I delete the field and Save, it returns on page refresh.
Regards,
Ruth
-- Software Manager & Engineer Blog: http://www.ivimey.org/blog LinkedIn: http://uk.linkedin.com/in/ruthivimeycook/